Tire TPU infill

[tom-f-oconnell]

What infill did you print your TPU tires with?

Googling around it seems like the 85A hardness Ninjaflex is the most common (and perhaps also the only one called just "Ninjaflex", but I'm not sure). Do you know whether this is also the hardness of the Ninjaflex you used?

Thanks again.

[XRobots]

Yep that's the one - just the standard stuff. It was 4 perimeters and around 40% infill - whatever made each tyre come out of one roll of filament basically. Previously I've used up to 80% infill for tyres which is practically solid.